Note

According to our information, you are currently in United States, where Blu Eye and Blu Eye GO are not operational at the moment. Keep me informed about updates

Home FAQ Registration & Activation Target Blu Eye

Support

Registration & Activation Target Blu Eye 1

Q: How do I register my Target Blu Eye 1?

Install Blu Eye in your vehicle before registering the system, and install the included antenna using Installer Mode (pre-installed on Blu Eye). This is the only way to ensure optimal performance. If you are using a Blu Eye that was previously installed in another vehicle, first download and activate Installer Mode to determine the best, interference-free location for the antenna. HOW TO OBTAIN YOUR ACTIVATION FILE Switch off the vehicle’s ignition. This will also turn off the Blu Eye system. Insert the supplied SD card into the SD card slot of your Blu Eye. Turn on the ignition. The unique serial number of your Blu Eye will now be copied to the SD card. All LEDs will turn on for 5 seconds. Once the 5 signal strength indicator LEDs turn off and only the 2 blue LEDs remain on, the process is complete (this takes approximately 5 seconds). Turn off the ignition. Remove the SD card from your Blu Eye. Insert the SD card into your computer’s SD card slot (PC or Mac). Click the "Browse" button to locate the file. You will be prompted to select the activation file with a unique serial number (UNIQUEID.TXT) stored on the SD card in order to register your system. Click "Browse", locate the SD card, and open the file "UNIQUEID". Click "Upload file".

Q: How do I activate my Target Blu Eye 1?

After Blu Eye has been installed, connected, and the antenna placement has been tested using Installer Mode, you need to activate the system. Follow these steps to complete the activation: Download the firmware. Copy the files to the SD card. (Important: Do not place the files in a folder and make sure the SD card contains no other files.) Remove the SD card from your computer. Turn off the Blu Eye system by switching off the vehicle’s ignition. If Blu Eye remains powered on for a short while after the ignition is turned off (depending on the vehicle’s CAN bus system), disconnect the power plug from the Blu Eye unit to shut it down completely. Insert the SD card into the Blu Eye’s SD card slot. Turn on the ignition. IMPORTANT: Never interrupt power to the Blu Eye system during the update process. All LEDs will light up for 5 seconds. During the initial registration and update process, copying the files to Blu Eye takes approximately 30 seconds. Various LEDs will illuminate during the update process. At the end, the LEDs will cycle step-by-step from red to green. The process is complete when the last green LED turns off.

How do I register my Target Blu Eye 1?

How do I activate my Target Blu Eye 1?

Back to categories

My cart

Registration & Activation Target Blu Eye 1

How do I register my Target Blu Eye 1?

How do I activate my Target Blu Eye 1?